Affiliate Disclosure: TruckBench is reader-supported. As an Amazon Associate, we earn from qualifying purchases made through links on this page, at no additional cost to you.
Top 10 Floor Liners for the 2016–2023 Toyota Tacoma
The third-generation Tacoma is built for muddy boots, wet gear and weekend trail runs, and the factory carpet mats don’t do much to protect the floor from any of it. A good floor liner uses a raised edge to trap water, mud, snow and spilled coffee, which keeps the carpet clean and helps resale value. The cab layout matters here: the Access Cab has a small rear jump-seat area, while the Double Cab has a full rear bench, so the number of pieces and the shape of the rear liner differ. Here are ten top options.
Note: Confirm your cab (Access Cab or Double Cab), your transmission (manual or automatic, since the footwell and dead-pedal area differ), and whether you have the factory rear underseat storage or a TRD Pro-specific mat before ordering. Liners are cut for specific model-year ranges, and a liner made for another year can interfere with the pedals.
1. WeatherTech FloorLiner HP (Front and Rear)
⭐⭐⭐⭐⭐ (4.8/5) — Badge: Best Overall
“Laser-measured to the floor of your exact cab — the benchmark for fit.”
WeatherTech digitally scans each vehicle, so the FloorLiner HP follows the contours of the Tacoma’s footwell closely and the raised edges reach up the sides of the floor. The HP version uses a high-performance material that stays flexible in cold weather and is less likely to crack or curl over time.
Fit is the biggest advantage. The liners lock onto the factory retention posts on the driver’s side so they don’t creep under the pedals, and the rear piece covers the Double Cab’s rear footwell in one sheet. They cost more than most rivals, but many owners keep the same set for years.
| Spec | Detail |
|---|---|
| Material | High-performance tri-extruded material |
| Coverage | Front and rear (cab-specific) |
| Fitment | 2016–2023 Tacoma (confirm cab and trans) |
| Retention | Factory driver-side posts |
Pros
- Excellent edge-to-edge fit
- Stays flexible in cold weather
- Locks to factory retention points
Cons
- Premium price
- Hard surface can be slick when wet
Price Range: $200–$280
2. 3D MAXpider Kagu Floor Mats
⭐⭐⭐⭐½ (4.6/5) — Badge: Best Deep-Tray Design
“A tall-walled tray with a grippy, carpet-like texture.”
The Kagu uses a multi-layer construction with a textured top surface that grips boots better than slick plastic, and a tall perimeter wall that holds more liquid than a typical mat. The rubber-like material resists odors and stays supple through temperature swings.
The finish looks closer to carpet than hard plastic, which many owners prefer inside the cab. The rear piece is sized to the cab so it covers the full rear footwell.
| Spec | Detail |
|---|---|
| Material | Multi-layer Kagu rubber |
| Coverage | Front and rear (cab-specific) |
| Fitment | 2016–2023 Tacoma (confirm cab) |
| Retention | Anchored with factory posts |
Pros
- Tall walls hold plenty of liquid
- Grippy textured surface
- Looks more upscale than hard plastic
Cons
- Slightly less precise at corners than laser-scanned rivals
- Higher price than basic mats
Price Range: $170–$260
3. Husky Liners X-act Contour Floor Liners
⭐⭐⭐⭐½ (4.5/5) — Badge: Best Value for Fit
“A form-fit liner with a durable, flexible material at a lower price.”
Husky’s X-act Contour liners are made from a flexible, odor-free thermoplastic that is designed to stay soft in cold weather and resist cracking. The shape follows the Tacoma’s footwell and uses a raised lip to catch spills.
They cost less than WeatherTech but cover the same ground for most owners. The textured top surface provides grip, and there’s a good selection of colors in some listings.
| Spec | Detail |
|---|---|
| Material | Flexible thermoplastic |
| Coverage | Front and rear options |
| Fitment | 2016–2023 Tacoma (confirm cab) |
| Retention | Factory posts where equipped |
Pros
- Good price for the quality
- Stays flexible in cold weather
- Solid coverage
Cons
- Not quite as tight at the edges as laser-scanned liners
- Some owners find the surface slick when wet
Price Range: $130–$210
4. TuxMat Custom-Fit Floor Mats
⭐⭐⭐⭐½ (4.5/5) — Badge: Best Premium Fit
“Digitally modeled liners with some of the tightest edges around.”
TuxMat uses laser-scanned vehicle data to cut each mat, and the result is a snug fit with raised edges that run high on the sides. The material has a soft-touch feel and a textured top to keep your feet from sliding.
The price is high, and availability can lag for newer variants, so confirm the listing covers your exact cab.
| Spec | Detail |
|---|---|
| Material | Premium flexible polymer |
| Coverage | Front and rear |
| Fitment | 2016–2023 Tacoma (confirm cab) |
| Retention | Factory posts |
Pros
- Very tight, clean fit
- Pleasant material feel
- High side walls
Cons
- Premium price
- Limited availability for some configurations
Price Range: $190–$290
5. Toyota Genuine All-Weather Floor Liners
⭐⭐⭐⭐ (4.3/5) — Badge: Best Factory Match
“Dealer-sourced liners engineered for the cab — no guesswork.”
Toyota’s all-weather liners are designed for the Tacoma and retain the original factory fixtures, so there’s no concern about pedal interference. They sit at a comfortable height and match the interior look.
They tend to cost more than some aftermarket options and have shallower walls than the deep-tray designs.
| Spec | Detail |
|---|---|
| Material | Rubber/thermoplastic |
| Coverage | Front and rear sets available |
| Fitment | Cab-specific |
| Retention | Factory posts |
Pros
- Guaranteed fit
- Matches the interior
- No pedal interference
Cons
- Shallower walls than deep-tray liners
- Higher price than some rivals
Price Range: $150–$300
6. Lund Catch-All Xtreme Floor Liners
⭐⭐⭐⭐ (4.2/5) — Badge: Best Budget Liner
“A deep-lipped liner at a price that’s hard to beat.”
Lund’s Catch-All Xtreme gives the Tacoma a raised-edge liner with channels that route liquid toward the center, and a textured surface for grip. It’s a cost-effective way to protect the carpet.
Fit is good but not as tight as laser-scanned alternatives, so you may notice small gaps near the edges.
| Spec | Detail |
|---|---|
| Material | Rubber-like composite |
| Coverage | Front and rear |
| Fitment | 2016–2023 Tacoma (confirm) |
| Retention | Posts or friction |
Pros
- Low price
- Raised edges
- Easy to clean
Cons
- Looser fit at edges
- Material can stiffen in cold weather
Price Range: $70–$130
7. Aries StyleGuard Floor Liners
⭐⭐⭐⭐ (4.2/5) — Badge: Best Value Pick
“A well-priced liner with a straightforward custom fit.”
ARIES’ StyleGuard liners follow the contours of the footwell and use a raised lip with a textured surface. They are priced between budget and premium options.
Review fitment for your cab.
| Spec | Detail |
|---|---|
| Material | Durable synthetic |
| Coverage | Front and rear |
| Fitment | 2016–2023 Tacoma (confirm) |
| Retention | Posts or friction |
Pros
- Good value
- Custom-fit contours
- Easy to clean
Cons
- Less refined edges
- Fewer colors
Price Range: $100–$170
8. Motor Trend FlexTough Floor Liners
⭐⭐⭐½ (3.9/5) — Badge: Best Budget Option
“A trim-to-fit option for owners on a tight budget.”
Motor Trend’s FlexTough mats are inexpensive and are often sold as universal or semi-custom. They protect the carpet at a low price, but fit is looser than with a custom liner.
They may need to be trimmed, and they don’t rise as high on the sides.
| Spec | Detail |
|---|---|
| Material | Rubber-like material |
| Coverage | Front (rear options vary) |
| Fitment | Verify for your cab |
| Retention | Friction |
Pros
- Very affordable
- Easy to clean
- Quick to install
Cons
- Looser, less precise fit
- Shallower edges
Price Range: $30–$70
9. OEDRO Floor Mats
⭐⭐⭐⭐ (4.0/5) — Badge: Best Mid-Price Custom Fit
“A custom-fit mat priced below the premium names.”
OEDRO sells custom-fit mats designed for specific vehicles at a lower price. They offer a raised lip and a textured surface, and they are popular as an upgrade from basic mats.
Quality control can vary, so check the return policy and test the fit around the pedals.
| Spec | Detail |
|---|---|
| Material | TPE-type material |
| Coverage | Front and rear |
| Fitment | 2016–2023 Tacoma (verify) |
| Retention | Friction/posts |
Pros
- Custom fit at a lower price
- Easy cleanup
- Odor-free in most reviews
Cons
- Quality varies
- Less brand support
Price Range: $80–$150
10. Armor All Heavy-Duty Rubber Floor Mats
⭐⭐⭐½ (3.8/5) — Badge: Best Entry-Level Pick
“Simple, inexpensive protection for the carpet.”
Armor All’s heavy-duty mats are an entry-level choice with a deep-groove pattern that catches some dirt and water. They’re easy to clean and affordable.
They are universal-fit, so they won’t cover the full footwell, and they can shift without retention.
| Spec | Detail |
|---|---|
| Material | Rubber |
| Coverage | Front (universal) |
| Fitment | Universal |
| Retention | Friction |
Pros
- Cheap
- Easy to clean
- Widely available
Cons
- Doesn’t cover the whole floor
- Can slide without retention
Price Range: $25–$50
Buying Guide: How to Choose Floor Liners for Your Toyota Tacoma
1. Match Your Cab Access Cab and Double Cab trucks have different rear floor shapes. Make sure the listing covers your cab and the number of pieces you need.
2. Check Transmission and Pedals Manual and automatic trucks have different footwell layouts. A mismatched liner can interfere with the pedals, so use the retention posts and verify the driver’s mat locks in place.
3. Laser-Scanned vs. Trim-to-Fit Laser-scanned liners (WeatherTech, TuxMat, 3D MAXpider) follow the contours more closely and hold more liquid. Trim-to-fit mats cost less but leave gaps.
4. Edge Height and Material Taller walls hold more water and snow. Flexible materials resist cracking in cold weather, which matters if you live somewhere that freezes.
5. Don’t Stack Mats Remove the factory carpet mat before installing a liner, since stacking can let the liner slide under the pedals.
Disclaimer: Prices and availability are accurate as of publication but may change. TruckBench earns a commission on qualifying purchases via the Amazon links above. Always secure the driver-side liner with the retention posts so it cannot interfere with the pedals.
Leave a Reply